Latest News:
|
X-Pole assembly
|
 |
 |
|
Step 1
- Check the contents Remove all the parts from the X-Pole box, lay them out, identify them and check the contents. |
Step 2
- Choose a Pole location Select your pole dancing location, measure the ceiling height and place the X-Pole base in position. |
 |
 |
|
Step 3
- Choose your extensions Use the height chart to select any extensions (if required). |
Step 4
- Locate the ceiling joists Locate the ceiling joists by tapping with a finger or using a stud/joist locator. Adjust the X-Pole base position to mid point between the joists. |
 |
 |
|
Step 5
- Fit the extensions to the base
(if required) Attach any extensions to base insert. Extensions always fit at the bottom of the pole smallest first. |
Step 6
- Attach lower main pole. Screw the lower main pole onto the extension or base insert. Tighten firmly by hand. |
 |
 |
|
Step 7
- Prepare Adjuster rod Take off the adjuster cover tube and wind the adjuster locking nut to the top of the adjuster. |
Step 8
- Fit adjuster Screw the adjuster into upper main dance pole until the nut touches the top of the pole. |
 |
 |
|
Step 9
- Fit adjuster cover Slide adjuster cover into position just covering the O-ring. |
Step 10
- Attach the Upper Dome Slide the upper dome onto adjuster shaft. X-Pole uses a long adjuster shaft with 3 bearings to lock the dome at 90 degrees to the Pole. |
 |
 |
|
Step 11
- Fit the poles together Attach upper pole assembly to lower pole. Screw up tightly and hold vertical. |
Step 12
- Tighten Adjuster Unscrew the adjuster by hand until it is firm against the ceiling. Make sure the upper dome is flat. |
 |
 |
|
Step 13
- Tighten the tubes Using the tightening and release rods tighten the pole sections firmly but not over tight. |
Step 14
- Final check Tighten the X-Pole adjuster with spanner until it is really firm. Check for movement and retighten if there is any movement. |
 |
 |
|
Step 15
- Fit adjuster Cover Slide the adjuster cover up, press in the two sprung pins and lock in place |
Step 16
- Ready to go! After a final check for movement X-pole is ready for use. Where ever it's used X-Pole is up and ready for action in minutes. Enjoy!!!!!!!! |
